meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
drives:teac_fd55gfv [2022/03/23 08:11] – Finished the spec table; added the jumper section and picture. flan | drives:teac_fd55gfv [2022/03/25 10:22] (current) – [Jumper Settings] Clarified that drive select doesn't matter much. flan | ||
---|---|---|---|
Line 22: | Line 22: | ||
^ Power | +5 V, +12 V | | ^ Power | +5 V, +12 V | | ||
^ Power dissipation | 5.2 watts operating, 1.8 W at rest | | ^ Power dissipation | 5.2 watts operating, 1.8 W at rest | | ||
- | ^ MTBF | 12,000 POH | | ||
- | ^ MTTR | < 15 minutes | ||
Physical specs: | Physical specs: | ||
Line 42: | Line 40: | ||
The following jumper settings are known to work with the Applesauce: | The following jumper settings are known to work with the Applesauce: | ||
- | ^ DS0 | Connected | + | ^ DCRY | RY | Disk Change/ |
- | ^ DS1 | Not connected | ::: | + | ^ DS0 |
- | ^ DS2 | Not connected | ::: | + | ^ DS1 |
- | ^ DS3 | Not connected | ::: | + | ^ DS2 |
- | ^ U1 | Not connected | Head load on motor on | | + | ^ DS3 |
- | ^ U2 | Connected | + | ^ U1 | Not connected | Head load on motor on | |
- | ^ HL | Not connected | Pin 4 is Head Load | | + | ^ U2 | Connected |
- | ^ IU | Not connected | Pin 4 is In Use | + | ^ HL | Not connected | Pin 4 is Head Load |
+ | ^ IU | Not connected | Pin 4 is In Use | | ||
+ | ^ LG-HG | HG (both!) | ||
- | {{:drives:teac_fd55gfv_jumpers.jpg? | + | < |
+ | {{: | ||