meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
drives:teac_fd55gfv [2022/03/23 08:12] – Removed MTBF and MTTR because they aren't in the sheet flandrives:teac_fd55gfv [2022/03/25 10:22] (current) – [Jumper Settings] Clarified that drive select doesn't matter much. flan
Line 40: Line 40:
 The following jumper settings are known to work with the Applesauce: The following jumper settings are known to work with the Applesauce:
  
-^ DS0 | Connected     | Drive select          | +^ DCRY  | RY            | Disk Change/Ready on line 34<sup>*</sup> | 
-^ DS1 | Not connected | :::                   | +^ DS0   | Connected     | Drive select (any drive number is fine)  | 
-^ DS2 | Not connected | :::                   | +^ DS1   | Not connected | :::                                      | 
-^ DS3 | Not connected | :::                   | +^ DS2   | Not connected | :::                                      | 
-^ U1  | Not connected | Head load on motor on | +^ DS3   | Not connected | :::                                      | 
-^ U2  | Connected     | :::                   | +^ U1    | Not connected | Head load on motor on                    | 
-^ HL  | Not connected | Pin 4 is Head Load    | +^ U2    | Connected     | :::                                      | 
-^ IU  | Not connected | Pin 4 is In Use       |+^ HL    | Not connected | Pin 4 is Head Load                       | 
 +^ IU    | Not connected | Pin 4 is In Use                          | 
 +^ LG-HG | HG (both!)    | Sets High Density input level            |
  
-{{:drives:teac_fd55gfv_jumpers.jpg?400|}}+<sup>*</sup> ⚠️ Make a note of the original setting if you change the DCRY jumper! See [[:howto:drivesetup#disk_change_ready_line_34|DISK CHANGE/READY]] for a more thorough explanation.
  
 +{{:drives:teac_fd55gfv_jumpers.jpg?400|}}