Differences

This shows you the differences between two versions of the page.

--- adv:apireference [2022/02/05 06:01] – created vintagetech
+++ adv:apireference [2023/12/22 20:15] – document the Direct Pin Access commands lord_nightmare
@@ Line 1: / Line 1: @@
 ====== Making your own Applesauce Software ======
@@ Line 230: / Line 229: @@
 ==== Direct Pin Access ====
+**pins:connect** – enables the '245
-pins:?map
+**pins:disconnect** – disables the '245
-pins:r
+**pins:?map** – prints the current pin map (dependent on drive kind, see ?kind)
-pins:wh
+**n** below is the pin number output from the pins:?map command.
-pins:wl
+**pins:i n** – sets pin n to input mode
-pins:i
+**pins:o n** – sets pin n to output mode
-pins:o
+**pins:r n** – returns “+” or “-” depending on the state of pin n
-pins:connect
+**pins:wh n** – writes logic level high to pin n
-pins:disconnect
+**pins:wl n** – writes logic level low to pin n