meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
drives:pc525 [2022/02/09 02:46] – [FD55-GFR] Added units flan | drives:pc525 [2022/03/22 20:48] – flan | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== 5.25" PC Floppy Drives ====== | ====== 5.25" PC Floppy Drives ====== | ||
- | Most PC drives | + | The Applesauce (rev 2 and higher) works with most PC floppy |
+ | |||
+ | ⚠️ The cable has two connectors, but **only connect one drive at a time**! | ||
+ | |||
+ | Drives can be configured to be either Drive 1 or Drive 2—the Applesauce will try both. The drive should also be configured | ||
+ | |||
+ | If the drive supports both low-density disks (300 RPM) and high-density disks (360 RPM), then it best to allow the Applesauce to control the speed. This way the client software can analyze the flux timings to figure out at which speed the disk was written, then switch to the correct speed for imaging. | ||
⚠️ **Always update the Drive Configuration after changing jumpers!** | ⚠️ **Always update the Drive Configuration after changing jumpers!** | ||
+ | |||
+ | ---- | ||
+ | |||
+ | ===== EPSON ===== | ||
+ | |||
+ | ==== SD-700 ==== | ||
+ | |||
+ | ^ Step time | ||
+ | ^ Settle time | 15 ms | | ||
+ | ^ Jumpers | ||
+ | |||
+ | [[drives: | ||
+ | |||
+ | ---- | ||
+ | |||
+ | ===== NEC ===== | ||
+ | |||
+ | ==== FD1157C ==== | ||
+ | |||
+ | ^ Step time | ||
+ | ^ Settle time | 15 ms | | ||
+ | ^ Jumpers | ||
+ | |||
+ | [[drives: | ||
+ | |||
+ | ---- | ||
===== TEAC ===== | ===== TEAC ===== | ||
Line 13: | Line 45: | ||
^ Model ^ Jumpers | ^ Model ^ Jumpers | ||
| 7193-U | RY, D1, I | {{ gallery: | | 7193-U | RY, D1, I | {{ gallery: | ||
+ | |||
+ | |||
+ | ==== FD55-GFV ==== | ||
+ | |||
+ | ^ Step time | ||
+ | ^ Settle time | 15 ms | | ||
+ | ^ Jumpers | ||
+ | |||
+ | [[drives: | ||
+ | |||
+ | ---- | ||