Differences

This shows you the differences between two versions of the page.

--- howto:sync_sensor [2022/02/07 02:23] – [How do I pick the correct Sync Sensor for my drive?] vintagetech
+++ howto:sync_sensor [2022/02/07 02:25] – [How do I install a Sync Sensor?] vintagetech
@@ Line 33: / Line 33: @@
 Detailed instructions for installing each of the sync sensors can be found below.
-|{{gallery:sync_alps525.jpg?direct |}}|{{gallery:sync_shug525.jpg?direct |}}|{{gallery:sync_uni525.jpg?direct |}}|{{gallery:sync_35.jpg?direct |}}|
+|{{gallery:sync_alps525.jpg?direct |Alps Sync Sensor}}|{{gallery:sync_shug525.jpg?direct |Shugart Sync Sensor}}|{{gallery:sync_uni525.jpg?direct |Unidisk 5.25 Sync Sensor}}|{{gallery:sync_35.jpg?direct |Apple 3.5 Sync Sensor}}|
 |[[Alps Sensor Installation|Alps Sensor Installation]]|[[Shugart Sensor Installation|Shugart Sensor Installation]]|[[Apple 5.25 Sensor Installation|Apple 5.25 Sensor Installation]]|[[Apple 3.5 Sensor Installation|Apple 3.5 Sensor Installation]]|
 When installing the sync sensor, be sure that the face of the sensor (the beveled side) is sitting parallel to the magnet surface. The magnet needs to be passing the sensor from one beveled edge to the other. For best signal, you want the sensor to be within 1.5mm of the magnet.
-{{ gallery:sync_magnet_drawing-1-300x189.png?direct&200 |}}
+{{ gallery:sync_magnet_drawing-1-300x189.png?direct&200 |Sync Sensor and Magnet Setup}}
 -----