meta data for this page
A Power Tap can be used to create your own custom power cables for use with Applesauce.
Maximum Load: +5V 1.5A / +12V 1.5A / -12V 100mA / 1.5A Total
- The 20-pin connector should be soldered to the PCB with the key on the side opposite of the writing, on the side with the little key graphic.
- The Power Tap fits wires up to 18ga and has built-in strain relief. Feed the wire upwards through the strain relief and then strip the wires, feed through the soldering holes and solder in place.
- Pull the excess wire back through the strain relief until it is taut.
- If you need more assembly instructions than this, you probably shouldn’t be trying to attempt this.