meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
drives:nec_fd1157c [2022/02/12 10:48] – [Jumper Settings] Added explanations for all of the jumper settings flan | drives:nec_fd1157c [2022/02/12 10:54] (current) – [Basic Disassembly] Added warning and wordsmithing. flan | ||
---|---|---|---|
Line 102: | Line 102: | ||
==== Basic Disassembly ==== | ==== Basic Disassembly ==== | ||
- | With the drive flat on a table, with door facing you, remove the screw on the right about midway down the chassis. This screw holds the RF shielding on. With the screw out, the shielding should slide forward towards the drive door, and then lift the back up. This should | + | ⚠️ **Use a J1 screwdriver or you will strip the screws!** Screws on this drive are type J1 JIS screws. [[https:// |
+ | |||
+ | With the drive flat on a table, with door facing you, remove the screw on the right about midway down the chassis. This screw holds the RF shielding on. With the screw out, the shielding should slide forward towards the drive door. Lift the back up. You should | ||
==== Extras ==== | ==== Extras ==== |