meta data for this page
This is an old revision of the document!
5.25" PC Floppy Drives
The Applesauce (rev 2 and higher) works with most PC floppy drives, but requires the PC Drive Cable kit. The cable in this kit is unique to Applesauce, so best to just buy it.
⚠️ The cable has two connectors, but only connect one drive at a time!
Drives can be configured to be either Drive 1 or Drive 2—the Applesauce will try both. The drive should also be configured for a non-twisted cable.
If the drive supports both low-density disks (300 RPM) and high-density disks (360 RPM), then it best to allow the Applesauce to control the speed. This way the client software can analyze the flux timings to figure out at which speed the disk was written, then switch to the correct speed for imaging.
⚠️ Always update the Drive Configuration after changing jumpers!
NEC
FD1157C
| Step time | 3 ms |
|---|---|
| Settle time | 15 ms |
| Jumpers | ?? |
TEAC
FD55-GFR
Step time: 3 ms (default is 5 ms)
| Model | Jumpers | Picture |
|---|---|---|
| 7193-U | RY, D1, I | TEAC FD55-GFR 7193-U |
