meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| drives:teac_fd55gfv [2022/03/23 08:11] – Finished the spec table; added the jumper section and picture. flan | drives:teac_fd55gfv [2022/03/23 10:30] – [Jumper Settings] Added DCRY and LG-HG flan | ||
|---|---|---|---|
| Line 22: | Line 22: | ||
| ^ Power | +5 V, +12 V | | ^ Power | +5 V, +12 V | | ||
| ^ Power dissipation | 5.2 watts operating, 1.8 W at rest | | ^ Power dissipation | 5.2 watts operating, 1.8 W at rest | | ||
| - | ^ MTBF | 12,000 POH | | ||
| - | ^ MTTR | < 15 minutes | ||
| Physical specs: | Physical specs: | ||
| Line 39: | Line 37: | ||
| ==== Jumper Settings ==== | ==== Jumper Settings ==== | ||
| + | |||
| + | ⚠️ **The DCRY jumper should be on DC for the Applesauce!** | ||
| The following jumper settings are known to work with the Applesauce: | The following jumper settings are known to work with the Applesauce: | ||
| - | ^ DS0 | Connected | + | ^ DCRY | DC | Disk Change/ |
| - | ^ DS1 | Not connected | ::: | + | ^ DS0 |
| - | ^ DS2 | Not connected | ::: | + | ^ DS1 |
| - | ^ DS3 | Not connected | ::: | + | ^ DS2 |
| - | ^ U1 | Not connected | Head load on motor on | | + | ^ DS3 |
| - | ^ U2 | Connected | + | ^ U1 | Not connected | Head load on motor on |
| - | ^ HL | Not connected | Pin 4 is Head Load | | + | ^ U2 | Connected |
| - | ^ IU | Not connected | Pin 4 is In Use | + | ^ HL | Not connected | Pin 4 is Head Load | |
| + | ^ IU | Not connected | Pin 4 is In Use | | ||
| + | ^ LG-HG | HG (both!) | ||
| {{: | {{: | ||
| - | |||