meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
drives:teac_fd55gfv [2022/03/23 08:12] – Removed MTBF and MTTR because they aren't in the sheet flandrives:teac_fd55gfv [2022/03/25 10:00] – Explained DCRY jumper; fixed warning flan
Line 40: Line 40:
 The following jumper settings are known to work with the Applesauce: The following jumper settings are known to work with the Applesauce:
  
-^ DS0 | Connected     | Drive select          | +^ DCRY  | RY            | Disk Change/Ready on line 34<sup>*</sup> | 
-^ DS1 | Not connected | :::                   | +^ DS0   | Connected     | Drive select                             | 
-^ DS2 | Not connected | :::                   | +^ DS1   | Not connected | :::                                      | 
-^ DS3 | Not connected | :::                   | +^ DS2   | Not connected | :::                                      | 
-^ U1  | Not connected | Head load on motor on | +^ DS3   | Not connected | :::                                      | 
-^ U2  | Connected     | :::                   | +^ U1    | Not connected | Head load on motor on                    | 
-^ HL  | Not connected | Pin 4 is Head Load    | +^ U2    | Connected     | :::                                      | 
-^ IU  | Not connected | Pin 4 is In Use       |+^ HL    | Not connected | Pin 4 is Head Load                       | 
 +^ IU    | Not connected | Pin 4 is In Use                          | 
 +^ LG-HG | HG (both!)    | Sets High Density input level            |
  
-{{:drives:teac_fd55gfv_jumpers.jpg?400|}}+<sup>*</sup> ⚠️ Make a note of the original setting if you change the DCRY jumper! See [[:howto:drivesetup#disk_change_ready_line_34|DISK CHANGE/READY]] for a more thorough explanation.
  
 +{{:drives:teac_fd55gfv_jumpers.jpg?400|}}