meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
drives:teac_fd55gfv [2022/03/23 10:05] – Added warning about the DCRY jumper. flandrives:teac_fd55gfv [2022/03/23 10:30] – [Jumper Settings] Added DCRY and LG-HG flan
Line 38: Line 38:
 ==== Jumper Settings ==== ==== Jumper Settings ====
  
-⚠️ **Do not change the DCRY jumper from the factory setting!**+⚠️ **The DCRY jumper should be on DC for the Applesauce!**
  
 The following jumper settings are known to work with the Applesauce: The following jumper settings are known to work with the Applesauce:
  
-^ DS0 | Connected     | Drive select          | +^ DCRY  | DC            | Disk Change/Ready on line 34  | 
-^ DS1 | Not connected | :::                   | +^ DS0   | Connected     | Drive select                  | 
-^ DS2 | Not connected | :::                   | +^ DS1   | Not connected | :::                           | 
-^ DS3 | Not connected | :::                   | +^ DS2   | Not connected | :::                           | 
-^ U1  | Not connected | Head load on motor on | +^ DS3   | Not connected | :::                           | 
-^ U2  | Connected     | :::                   | +^ U1    | Not connected | Head load on motor on         | 
-^ HL  | Not connected | Pin 4 is Head Load    | +^ U2    | Connected     | :::                           | 
-^ IU  | Not connected | Pin 4 is In Use       |+^ HL    | Not connected | Pin 4 is Head Load            | 
 +^ IU    | Not connected | Pin 4 is In Use               | 
 +^ LG-HG | HG (both!)    | Sets High Density input level |
  
 {{:drives:teac_fd55gfv_jumpers.jpg?400|}} {{:drives:teac_fd55gfv_jumpers.jpg?400|}}