Differences

This shows you the differences between two versions of the page.

--- adv:powertap [2022/02/07 02:56] – vintagetech
+++ tinker:powertap [2022/11/12 23:59] – removed - external edit (Unknown date) 127.0.0.1
@@ Line 1: / Line 1: @@
-====== Power Tap ======
-A Power Tap can be used to create your own custom power cables for use with Applesauce.
-{{ gallery:powertap_assembly.jpg?direct&600 |Power Tap Assembly}}
-Maximum Load: +5V 1.5A / +12V 1.5A / -12V 100mA / 1.5A Total
-==== Assembly Instructions ====
-    - The 20-pin connector should be soldered to the PCB with the key on the side opposite of the writing, on the side with the little key graphic.
-    - The Power Tap fits wires up to 18ga and has built-in strain relief. Feed the wire upwards through the strain relief and then strip the wires, feed through the soldering holes and solder in place.
-    - Pull the excess wire back through the strain relief until it is taut.
-    - If you need more assembly instructions than this, you probably shouldn’t be trying to attempt this.